Recently Updated Pages

✅ Steps: 1. Connect the Dev Chip Board to a USB port on your Mac. 2. A dialog box will appear: ...

Congratulations! You have developed a complete SPI communication project using the ChipInventor p...

1. Go to the Simulate tab and select Advanced Simulation. 2. Run Iverilog. 3. Check the console...

1. Open ChipInventor. 2. Click New Project. 3. Fill in the fields: Name: SPI Communication T...

Congratulations! You have developed a complete I2C communication project using the ChipInventor p...

With the system programmed, perform the tests: View the values read from the ADC. Valid...

In this tutorial, we will create a project that uses the I2C protocol to read data from an ADC (A...

Congratulations! You’ve implemented a complete UART system with receiving, comparison, and data e...

Go to the Simulate tab in the top menu. Select Advanced Simulation. Click on Run Iv...

In this tutorial, you will create a serial communication system using UART with three main blocks...

This project implements a RISC-V core packaged in a microcontroller, featuring the 32-bit base IS...

This project implements a 64-point FFT-based audio processing system that captures audio from an ...

Implement a rear-view camera system using the Tang Primer 20K FPGA. The project utilizes the capa...

This project allows users to adjust the PWM duty cycle by incrementing or decrementing it in step...

This project is about a motor control unit that receives the PWM duty cycle via CAN, generates a ...

The objective of this project is to simulate the FPGA (Tang Primer 20K) as a HID keyboard via USB...

To test the INOUT block, we recommend that you access the "Accelerometer Reader" project within t...

In this tutorial, you learned how to configure and connect blocks in ChipInventor to create an SP...

After programming the FPGA, let’s test the hardware: On the top menu, click Main. Acces...

In this tutorial, you will learn how to develop and program an FPGA project using ChipInventor, w...